Matthias,
I did attempts to install from different clean directories.
the same answer ---configuring incomplete...errors. I can send you results of cmake configuring and cmake.log if you don't mind.
As concern to ~/ or $Home there is an identical result no changes. The make installation and build
files in pyalps directory are not changed. The are
old ones formatted in date of installation two months ago. Sure it is clear because I don't reach 'make'
executing.
You didn't answered me what kind of to uninstall
to do in the future. Please prompt me if such action is needed.
Best regards
Algis
On Sun, Apr 24, 2011 at 6:14 PM, Matthias Troyer
<troyer@phys.ethz.ch> wrote:
On Apr 24, 2011, at 4:54 PM, Algis Garliauskas wrote:
> Oh, Hi Dear Matthias,
> I very hard disappointed on an installing as ALPS1 and ALPS2.
> I lost even I had: ALPS2 was installed successfully til make test with tree mistakes but I didn't noticed next step "make install".
> After some numeric manipulations fighting with test errors I lost what I have - installing of ALPS2. Any tryings to restore installation were not succeeded. You in one letter to user
> have written that before new attempt of configuring cmake or make
> it is needed to destroy old installing.
Just build it in a clean directory.
> What kind command is in uninstall? My boost/boost is in ~/Alps2/alps2/boost/boost.This long path is from my no experience.
The ~ does not work in paths. You need to write the full explicit path to the place where you installed boost.
Matthias
--
Algis Garliauskas
Prof., Hab. dr. Vilnius University
Institute of Mathematics & Informatics
Akademijos 4, LT-6883, Vilnius, Lithuania
Tel.:370 5 2109333